Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:carb01f [2019/09/15 04:40] hippysmack [Rebuilding the Tollotson Carb] |
techtalk:ih:carb01f [2019/09/25 20:42] hippysmack [Welch Plug or Expansion Plug] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| \\ | \\ | ||
| ====== Rebuilding the Tillotson Carb ====== | ====== Rebuilding the Tillotson Carb ====== | ||
| + | See also in the Sportsterpedia: \\ | ||
| + | * [[techtalk:ih:carb01#tillotson_hd_carb_1966-1971|Tillotson Carb Basic Information]] | ||
| + | * [[techtalk:ih:carb01e|Tillotson Carb Identification]] | ||
| + | * [[techtalk:ih:carb01g|Tillotson Carb Functions, Adjustments, Tuning]] | ||
| ====== Cleaning ====== | ====== Cleaning ====== | ||
| * The general appearance of the inside of the carb is not necessarily a good indication of its condition. \\ It can look spotless and have clogged jets, or look cruddy and have clear jets. | * The general appearance of the inside of the carb is not necessarily a good indication of its condition. \\ It can look spotless and have clogged jets, or look cruddy and have clear jets. | ||
| Line 50: | Line 54: | ||
| * Installation: ((HD Service Bulletin #518 dated September 10, 1965 pg OC-189))((1959-1969 HD Sportster FSM)). | * Installation: ((HD Service Bulletin #518 dated September 10, 1965 pg OC-189))((1959-1969 HD Sportster FSM)). | ||
| * The plug should be seated with a flat end punch that is slightly smaller than the diameter of the plug. The plug should be flat and not concaved to assure a tight fit. If leakage is suspected due to a rough or damaged welch plug seat in the casting, apply a small amount of epoxy or suitable sealant to the edges after installing it. | * The plug should be seated with a flat end punch that is slightly smaller than the diameter of the plug. The plug should be flat and not concaved to assure a tight fit. If leakage is suspected due to a rough or damaged welch plug seat in the casting, apply a small amount of epoxy or suitable sealant to the edges after installing it. | ||
| - | * Installation Recommendations from Hubbard Spring [[http://www.hubbardspring.com/install_reco.php?cid=45]] | + | |
| - | * Some Welch Plug dims: [[http://www.hubbardspring.com/index.php/category/43/cupped-plugs-and-cupped-plugs-pierced-catalog]] | + | Links to Welch plug sites: \\ |
| + | * [[https://www.hubbardspring.com/product-category/expansion-plugs/hubbard-expansion-plugs/|M.D. Hubbard Spring Co.]] | ||
| ===== Links,Parts and Services for Tillotson Carbs ===== | ===== Links,Parts and Services for Tillotson Carbs ===== | ||
