Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:carb01f [2019/09/15 05:48] hippysmack [Rebuilding the Tillotson Carb] |
techtalk:ih:carb01f [2019/09/25 20:42] hippysmack [Welch Plug or Expansion Plug] |
||
---|---|---|---|
Line 54: | Line 54: | ||
* Installation: ((HD Service Bulletin #518 dated September 10, 1965 pg OC-189))((1959-1969 HD Sportster FSM)). | * Installation: ((HD Service Bulletin #518 dated September 10, 1965 pg OC-189))((1959-1969 HD Sportster FSM)). | ||
* The plug should be seated with a flat end punch that is slightly smaller than the diameter of the plug. The plug should be flat and not concaved to assure a tight fit. If leakage is suspected due to a rough or damaged welch plug seat in the casting, apply a small amount of epoxy or suitable sealant to the edges after installing it. | * The plug should be seated with a flat end punch that is slightly smaller than the diameter of the plug. The plug should be flat and not concaved to assure a tight fit. If leakage is suspected due to a rough or damaged welch plug seat in the casting, apply a small amount of epoxy or suitable sealant to the edges after installing it. | ||
- | * Installation Recommendations from Hubbard Spring [[http://www.hubbardspring.com/install_reco.php?cid=45]] | + | |
- | * Some Welch Plug dims: [[http://www.hubbardspring.com/index.php/category/43/cupped-plugs-and-cupped-plugs-pierced-catalog]] | + | Links to Welch plug sites: \\ |
+ | * [[https://www.hubbardspring.com/product-category/expansion-plugs/hubbard-expansion-plugs/|M.D. Hubbard Spring Co.]] | ||
===== Links,Parts and Services for Tillotson Carbs ===== | ===== Links,Parts and Services for Tillotson Carbs ===== |