Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ih:carb01l [2019/10/06 01:27] hippysmack [Pump diaphragm] |
techtalk:ih:carb01l [2019/10/06 01:29] hippysmack [Accelerator pump shaft] |
||
|---|---|---|---|
| Line 203: | Line 203: | ||
| ==== Accelerator pump shaft ==== | ==== Accelerator pump shaft ==== | ||
| + | Inspect the accelerator pump rod for bending. Inspect the rubber boot for cracks / tears. Any dirt that gets past the boot into the accelerator pump passage should be blown out from the side opposite of the nozzle (or check valve will close, making cleaning impossible). \\ | ||
| {{ :techtalk:ih:carb:bendix_carb_and_parts_by_schutzhund9.jpg?direct&300| }} \\ | {{ :techtalk:ih:carb:bendix_carb_and_parts_by_schutzhund9.jpg?direct&300| }} \\ | ||
| Line 211: | Line 211: | ||
| You can use most of the parts in this kit but purchase the Harley Part (#27762-71TA). \\ | You can use most of the parts in this kit but purchase the Harley Part (#27762-71TA). \\ | ||
| Aftermarket rebuild kit: \\ | Aftermarket rebuild kit: \\ | ||
| - | |||
| There are 3 holes in the accelerator pump shaft to provide more or less fuel upon acceleration. \\ | There are 3 holes in the accelerator pump shaft to provide more or less fuel upon acceleration. \\ | ||
