Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:carb01l [2019/11/14 05:08] hippysmack [Setting the float level] |
techtalk:ih:carb01l [2019/11/14 05:10] hippysmack [Setting the float level] |
||
---|---|---|---|
Line 101: | Line 101: | ||
Install the main jet snug, plus a little. Don't over tighten. \\ | Install the main jet snug, plus a little. Don't over tighten. \\ | ||
- | {{:techtalk:ih:carb:asetting_bendix_float_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) {{:techtalk:ih:carb:bendix_float_and_spring_4_by_dirtyharry68.jpg?direct&300|}} ((photo by DirtyHarry68 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072203&page=7)) \\ | + | {{:techtalk:ih:carb:setting_bendix_float_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) {{:techtalk:ih:carb:bendix_float_and_spring_4_by_dirtyharry68.jpg?direct&300|}} ((photo by DirtyHarry68 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072203&page=7)) \\ |
==== Installing the Float Spring ==== | ==== Installing the Float Spring ==== |