Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ih:carb01l [2019/11/14 05:08] hippysmack [Setting the float level] |
techtalk:ih:carb01l [2020/04/01 20:15] hippysmack [IH: Carburetor, Intake Manifold & Exhaust Systems - Sub-01L] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
| - | ====== IH: Carburetor, Intake Manifold & Exhaust Systems - Sub-01L ====== | + | ====== IH: Carburetor, Intake Manifold & Exhaust - Sub-01L ====== |
| \\ | \\ | ||
| ====== Rebuilding the Bendix Carb ====== | ====== Rebuilding the Bendix Carb ====== | ||
| Line 101: | Line 101: | ||
| Install the main jet snug, plus a little. Don't over tighten. \\ | Install the main jet snug, plus a little. Don't over tighten. \\ | ||
| - | {{:techtalk:ih:carb:asetting_bendix_float_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) {{:techtalk:ih:carb:bendix_float_and_spring_4_by_dirtyharry68.jpg?direct&300|}} ((photo by DirtyHarry68 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072203&page=7)) \\ | + | {{:techtalk:ih:carb:setting_bendix_float_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) {{:techtalk:ih:carb:bendix_float_and_spring_4_by_dirtyharry68.jpg?direct&300|}} ((photo by DirtyHarry68 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2072203&page=7)) \\ |
| ==== Installing the Float Spring ==== | ==== Installing the Float Spring ==== | ||
