Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:carb01m [2019/09/09 22:55] hippysmack [High throttle on startup] |
techtalk:ih:carb01m [2019/09/09 23:59] hippysmack [Throttle Cable] |
||
---|---|---|---|
Line 87: | Line 87: | ||
The cable is straight and the bell crank on the carb turns in a circular motion around the pivot point of the butterfly shaft. \\ | The cable is straight and the bell crank on the carb turns in a circular motion around the pivot point of the butterfly shaft. \\ | ||
{{:techtalk:ih:carb:bendix_throttle_cable_mech_by_piniongear.jpg?direct&400|}} ((drawing by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?p=3446817#post3446817)) \\ | {{:techtalk:ih:carb:bendix_throttle_cable_mech_by_piniongear.jpg?direct&400|}} ((drawing by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?p=3446817#post3446817)) \\ | ||
+ | |||
+ | When swapping carbs on different year models, you need a different grip/spiral. \\ | ||
+ | You can see the two different type spirals here. One for a pull (Bendix) and one for a push (Tillotson). \\ | ||
+ | {{:techtalk:ih:carb:throttle_grips_by_sleighcrane.jpg?direct&300|}} \\ | ||
\\ | \\ | ||
Line 294: | Line 298: | ||
The red arrow indicates the point where the throttle closes against the idle screw. \\ | The red arrow indicates the point where the throttle closes against the idle screw. \\ | ||
With the lever in this position you can look into the carb and the butterfly should be firmly closed. \\ | With the lever in this position you can look into the carb and the butterfly should be firmly closed. \\ | ||
+ | If not, ease up on the cable tension to allow the throttle plate to fully close. \\ | ||
{{:techtalk:ih:carb:bendix_pic_6_by_piniongear.jpg?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=1068009&page=3)) \\ | {{:techtalk:ih:carb:bendix_pic_6_by_piniongear.jpg?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=1068009&page=3)) \\ | ||