Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:carb01m [2019/09/09 22:58] hippysmack [High throttle on startup] |
techtalk:ih:carb01m [2019/09/11 02:33] hippysmack [Throttle Cable] |
||
|---|---|---|---|
| Line 87: | Line 87: | ||
| The cable is straight and the bell crank on the carb turns in a circular motion around the pivot point of the butterfly shaft. \\ | The cable is straight and the bell crank on the carb turns in a circular motion around the pivot point of the butterfly shaft. \\ | ||
| {{:techtalk:ih:carb:bendix_throttle_cable_mech_by_piniongear.jpg?direct&400|}} ((drawing by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?p=3446817#post3446817)) \\ | {{:techtalk:ih:carb:bendix_throttle_cable_mech_by_piniongear.jpg?direct&400|}} ((drawing by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?p=3446817#post3446817)) \\ | ||
| + | |||
| + | If you want to swap from a Tillotson to a Bendix, you will have to purchase a reverse grip spiral. Look up part# 56220-58 at J&P Cycles. ((piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=757993&page=4)) \\ | ||
| + | You can see the two different type spirals here. One for a pull (Bendix) and one for a push (Tillotson). \\ | ||
| + | {{:techtalk:ih:carb:throttle_grips_by_sleighcrane.jpg?direct&300|}} ((photo by sleighcrane of the XLFORUM http://xlforum.net/forums/showthread.php?p=5747569&highlight=bendix#post5747569)) \\ | ||
| \\ | \\ | ||
