Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:carb01m [2019/09/09 22:58] hippysmack [High throttle on startup] |
techtalk:ih:carb01m [2019/09/11 02:35] hippysmack [Throttle Cable] |
||
---|---|---|---|
Line 87: | Line 87: | ||
The cable is straight and the bell crank on the carb turns in a circular motion around the pivot point of the butterfly shaft. \\ | The cable is straight and the bell crank on the carb turns in a circular motion around the pivot point of the butterfly shaft. \\ | ||
{{:techtalk:ih:carb:bendix_throttle_cable_mech_by_piniongear.jpg?direct&400|}} ((drawing by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?p=3446817#post3446817)) \\ | {{:techtalk:ih:carb:bendix_throttle_cable_mech_by_piniongear.jpg?direct&400|}} ((drawing by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?p=3446817#post3446817)) \\ | ||
+ | |||
+ | If you want to swap from a Tillotson to a Bendix, you will have to purchase a reverse grip spiral. Look up part# 56220-58 at J&P Cycles. ((piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=757993&page=4)) \\ | ||
+ | The reason you need this is because the Tillotson opens up by rolling the throttle back to open the carb. This is normal. \\ | ||
+ | If you stick a Bendix on the bike with your same throttle, you will find that to open the throttle you will be rolling the throttle forward. \\ | ||
+ | The reason for this is because of the two carbs butterfly actuator opens differently from each other. \\ | ||
+ | You can see the two different type spirals here. One for a pull (Bendix) and one for a push (Tillotson). \\ | ||
+ | {{:techtalk:ih:carb:throttle_grips_by_sleighcrane.jpg?direct&300|}} ((photo by sleighcrane of the XLFORUM http://xlforum.net/forums/showthread.php?p=5747569&highlight=bendix#post5747569)) \\ | ||
\\ | \\ | ||