Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:ih:carb01q [2020/04/01 20:07]
hippysmack [IH: Carburetor, Intake Manifold & Exhaust - Sub-01Q]
techtalk:ih:carb01q [2020/05/31 00:11]
brianbbs67 [Disassembly]
Line 1: Line 1:
 [[:​techtalk:​menu|{{ ​ :​techtalk:​gototechnicalmenu.jpg|}}]] [[:​techtalk:​menu|{{ ​ :​techtalk:​gototechnicalmenu.jpg|}}]]
-====== IH: Carburetor, Intake Manifold & Exhaust ​Systems ​- Sub-01Q ======+====== IH: Carburetor, Intake Manifold & Exhaust - Sub-01Q ======
 \\ \\
 \\ \\
Line 24: Line 24:
     * **Note**: Some carbs, notably 1966 to 1978 Sportster carbs, do not have the O-ring and washer in the pilot screw passage.     * **Note**: Some carbs, notably 1966 to 1978 Sportster carbs, do not have the O-ring and washer in the pilot screw passage.
   * **Float bowl**:   * **Float bowl**:
-    * Remove the three screws and washers holding the bowl on the carb body.+    * Remove the Four screws and washers holding the bowl on the carb body.
     * Removing the float bowl will also allow you to remove the accelerator pump rod and boot and access to the jets. \\ Be careful not to damage the accel pump nozzle and overflow pipe which are built into the bowl.     * Removing the float bowl will also allow you to remove the accelerator pump rod and boot and access to the jets. \\ Be careful not to damage the accel pump nozzle and overflow pipe which are built into the bowl.
     * Remove the screw that holds the float pin, pin and float.     * Remove the screw that holds the float pin, pin and float.