Table of Contents
This is an old revision of the document!
IH: Carburetor, Intake Manifold & Exhaust
See also Installation of Top End for proper alignment of intake manifold.
Intake Manifold
Seals - Intake to Heads
Intake to Head - Hardware History. 1)2) | OEM Part Numbers | |
---|---|---|
1957-78 | Used exact same port sealing machining, heads and manifolds | Uses O-rings - 27060-55 - Clamp 27063-57. |
1979 | Confusing because it had the o-ring machining but used rubber bands | Uses rubber bands - 27062-78 - Clamp 27063-78. |
1980-later | Made with “o-ring delete” machining. | Uses rubber bands - 27062-78 - Clamp 27063-78. |
1979 models could retro fit 78-earlier interface mechanisms as a bolt on mod. | ||
1980-later models needed the heads to be machined for reverting to the straight up o-ring seals. |
Bendix
Keihin Butterfly
These V-twin clamps (35-0419) work well for stopping intake leaks. The tool to install them is the same as any oiteker clamp pliers. 7)
8) 9)
1)
See Brucstoudt & Dr_Dick - XLForum - http://xlforum.net/forums/showthread.php?t=2079889
3)
, 4)
, 5)
, 6)
photo by The Doctor71 of the XLFORUM http://xlforum.net/forums/showthread.php?t=2071371
7)
66xlch of the XLFORUM http://xlforum.net/forums/showthread.php?t=1079081&page=5
8)
photo by 66xlch of the XLFORUM http://xlforum.net/forums/showthread.php?t=1079081&page=5
9)
photo by DirtyCory of the XLFORUM http://xlforum.net/forums/showthread.php?t=1079081&page=7