Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:elec02 [2018/06/09 04:13] hippysmack [Fuse-able Link] |
techtalk:ih:elec02 [2018/07/11 00:01] ixl2relax [Fuse-able Link] |
||
---|---|---|---|
Line 7: | Line 7: | ||
* On XLCH, the wire was connected to the battery "+" terminal and to the red wire connector in conduit leading to the regulator "B+" terminal. | * On XLCH, the wire was connected to the battery "+" terminal and to the red wire connector in conduit leading to the regulator "B+" terminal. | ||
* Before replacing the fuse wire, check for shorts in the wiring or the ignition switch to determine the cause of the burnout. | * Before replacing the fuse wire, check for shorts in the wiring or the ignition switch to determine the cause of the burnout. | ||
+ | |||
+ | \\ | ||
+ | |||
+ | |||
====== Generator ====== | ====== Generator ====== | ||
Line 19: | Line 23: | ||
* The internal spline of the old style drive gear will not properly match the spline on the new armature shaft. | * The internal spline of the old style drive gear will not properly match the spline on the new armature shaft. | ||
* __Do not use the new style voltage regulator (74504-82) with a 10 amp generator, component damage can result__. | * __Do not use the new style voltage regulator (74504-82) with a 10 amp generator, component damage can result__. | ||
+ | |||
+ | See these XLForum Threads regarding Generator Operation & Testing:\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=39146\\ | ||
+ | http://xlforum.net/forums/showthread.php?t=559976\\ | ||
+ | |||
+ | \\ | ||
+ | |||
====== Starter Relay ====== | ====== Starter Relay ====== |