Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:elec02 [2020/03/13 19:34] hippysmack [Generator] |
techtalk:ih:elec02 [2020/11/11 06:40] hippysmack [Generator] |
||
---|---|---|---|
Line 105: | Line 105: | ||
====== Generator ====== | ====== Generator ====== | ||
+ | Removal: \\ | ||
+ | There is a trick to removing the generator: Lift up on the inner end and hold down on the outer end then remove it. ((IronMick of the XLFORUM http://xlforum.net/forums/showthread.php?p=754976)) \\ | ||
===== Sub Documents ===== | ===== Sub Documents ===== | ||
Line 121: | Line 123: | ||
http://xlforum.net/forums/showthread.php?t=39146\\ | http://xlforum.net/forums/showthread.php?t=39146\\ | ||
http://xlforum.net/forums/showthread.php?t=559976\\ | http://xlforum.net/forums/showthread.php?t=559976\\ | ||
+ | |||
+ | ===== Polarizing ===== | ||
+ | |||
+ | Polarizing procedure is same for positive or negative ground, 6 or 12 volt. \\ | ||
+ | The purpose of polarizing is to tell the generator whether to output positive or negative ground. \\ | ||
+ | |||
\\ | \\ | ||
Line 148: | Line 156: | ||
====== Voltage Regulator ====== | ====== Voltage Regulator ====== | ||
- | * {{ :pdf:regulator_test_specs.pdf |Voltage Regulator Test Specs - PDF}} (revised 2-70). | + | Regulator Test Specifications (as revised 2-70). |
+ | |||
+ | {{:techtalk:ih:elec:ih-regulator-test-specs_by_ixl2relax.jpg?direct&700|}} ((photo by IXL2Relax)) | ||
\\ | \\ |