Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:elec02a [2018/12/16 19:37] hippysmack [Bench Testing a Generator] |
techtalk:ih:elec02a [2018/12/16 19:41] hippysmack |
||
---|---|---|---|
Line 23: | Line 23: | ||
* There are no short circuits. | * There are no short circuits. | ||
* And the commutator, brushes and bearings are clean and in good order. | * And the commutator, brushes and bearings are clean and in good order. | ||
+ | \\ | ||
+ | \\ | ||
====== Brush assembly ====== | ====== Brush assembly ====== | ||
- | The brush plate is easily removable, and inspection/ cleanup should be straight forward. \\ | + | {{ :techtalk:ih:elec:generator_pic_by_sifty.jpg?direct&400|}} |
+ | The brush plate is easily removable, and inspection/ cleanup should be straight forward. ((photo by sifty of the XLFORUM ((http://xlforum.net/forums/showthread.php?t=1592463&page=42)) \\ | ||
Care must be taken when installing the brush plate. \\ | Care must be taken when installing the brush plate. \\ | ||
Make sure that the brush- armature connecting wire is not pinched (can short circuit to the frame). \\ | Make sure that the brush- armature connecting wire is not pinched (can short circuit to the frame). \\ | ||
Line 36: | Line 38: | ||
And make sure the bare end of the armature brush wire does not contact the case or end cap on assembly. | And make sure the bare end of the armature brush wire does not contact the case or end cap on assembly. | ||
- | {{:techtalk:ih:elec:generator_pic_by_sifty.jpg?direct&400|}} ((photo by sifty of the XLFORUM ((http://xlforum.net/forums/showthread.php?t=1592463&page=42)) | ||