Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:elec03 [2019/10/07 23:44] hippysmack [Horn] |
techtalk:ih:elec03 [2019/10/08 14:10] hippysmack [Horn] |
||
---|---|---|---|
Line 177: | Line 177: | ||
There are horn rebuild kits available, but they are pretty simple in design and a good cleaning may be all that is needed. \\ | There are horn rebuild kits available, but they are pretty simple in design and a good cleaning may be all that is needed. \\ | ||
- | {{:techtalk:ih:elec:delco-remy_horn_rebuild_1_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=965512)) | + | {{:techtalk:ih:elec:delco-remy_horn_rebuild_10_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=962963&highlight=diaphragm)) {{:techtalk:ih:elec:delco-remy_horn_rebuild_1_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=965512)) |
A bench grinder was used to grind the rivet faces off flat. You can also use a drill bit that is larger than the hole in the rivets to drill off the face. \\ | A bench grinder was used to grind the rivet faces off flat. You can also use a drill bit that is larger than the hole in the rivets to drill off the face. \\ |