Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:elec03 [2019/10/08 14:10] hippysmack [Horn] |
techtalk:ih:elec03 [2019/10/08 14:17] hippysmack [Horn] |
||
---|---|---|---|
Line 176: | Line 176: | ||
This is a rebuild of the stock Delco Remy horn from a 68 XLCH. \\ | This is a rebuild of the stock Delco Remy horn from a 68 XLCH. \\ | ||
There are horn rebuild kits available, but they are pretty simple in design and a good cleaning may be all that is needed. \\ | There are horn rebuild kits available, but they are pretty simple in design and a good cleaning may be all that is needed. \\ | ||
+ | The repop one from J&P Cycles is on the right (3rd pic below). It has 2 wire connections as opposed to the single wire connection on the original horn. \\ | ||
- | {{:techtalk:ih:elec:delco-remy_horn_rebuild_10_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=962963&highlight=diaphragm)) {{:techtalk:ih:elec:delco-remy_horn_rebuild_1_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=965512)) | + | {{:techtalk:ih:elec:delco-remy_horn_rebuild_10_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=962963&highlight=diaphragm)) {{:techtalk:ih:elec:delco-remy_horn_rebuild_1_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=965512)) {{:techtalk:ih:elec:delco-remy_horn_rebuild_11_by_68iron.jpg?direct&300|}} ((photo by 68iron of the XLFORUM http://xlforum.net/forums/showthread.php?t=962963&highlight=diaphragm)) \\ |
A bench grinder was used to grind the rivet faces off flat. You can also use a drill bit that is larger than the hole in the rivets to drill off the face. \\ | A bench grinder was used to grind the rivet faces off flat. You can also use a drill bit that is larger than the hole in the rivets to drill off the face. \\ |