Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
techtalk:ih:engctl01 [2023/12/30 03:28] hippysmack |
techtalk:ih:engctl01 [2024/05/05 02:12] ixl2relax [Spark Coil] |
||
---|---|---|---|
Line 91: | Line 91: | ||
===== Spark Coil ===== | ===== Spark Coil ===== | ||
+ | |||
+ | **Coil Spec for Points Ignition** | ||
+ | * Resistances on a Points-based Ignition Coil should be: | ||
+ | * Primary: 4.7-5.5 Ohms | ||
+ | * Secondary: 16,000-20,000 Ohms | ||
+ | |||
**Coil Mix-up on 1973-1974 Models** | **Coil Mix-up on 1973-1974 Models** | ||
Line 99: | Line 105: | ||
**Failed Coils on 1980 Models** | **Failed Coils on 1980 Models** | ||
- | * A quantity of ignition coils (31609-80) used on all 1980 models, failed at low mileage. The problem was an internal breakdown of the windings within the coil. This is a failure that could lead to poor vehicle performance and a possible fouled spark plug. ((HD Service Bulletin #M-793 dated July 3, 1980)) | + | * A quantity of ignition coils (31609-80) used on all 1980 models (electronic ignition system), failed at low mileage. The problem was an internal breakdown of the windings within the coil. This is a failure that could lead to poor vehicle performance and a possible fouled spark plug. ((HD Service Bulletin #M-793 dated July 3, 1980)) |
* Upon inspection of an ignition related failure, follow the diagnostic procedure outlined in the service manual. Inspect the primary and secondary coil resistance with an ohmmeter. | * Upon inspection of an ignition related failure, follow the diagnostic procedure outlined in the service manual. Inspect the primary and secondary coil resistance with an ohmmeter. | ||
- | * Resistances should be: | + | * Resistances on an Electronic Ignition Coil should be: |
* Primary: 3.3-3.7 Ohms | * Primary: 3.3-3.7 Ohms | ||
* Secondary: 16500-19500 Ohms | * Secondary: 16500-19500 Ohms |