Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:engctl02 [2019/06/23 00:46] hippysmack [Starter Motor Variations] |
techtalk:ih:engctl02 [2019/06/23 01:06] hippysmack [Solenoids] |
||
---|---|---|---|
Line 58: | Line 58: | ||
====== Solenoids ====== | ====== Solenoids ====== | ||
+ | 67 and Up XLH Starter solenoid (71469-65) \\ | ||
+ | Below, the 1/4" solenoid mounting threads were stripped (nut on the top bolt) so they were tapped out for 8mm cap screws. ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) \\ | ||
+ | 8mm x 1.25 threads have almost exactly the same thread pitch as the original 1/4" thread. \\ | ||
+ | Then the mounting bracket and and spacer were drilled 8mm and the solenoid was installed using allen head cap screws and spring washers. \\ | ||
+ | |||
+ | | Starter solenoid (71469-65) ((photo by sifty of the XLFORUM http://xlforum.net/forums/showthread.php?t=1592463&page=27)) | | ||
+ | |{{:techtalk:ih:engctl:solenoid_switch_1_by_sifty.jpg?direct&300|}}|{{:techtalk:ih:engctl:solenoid_switch_2_by_sifty.jpg?direct&300|}}|{{:techtalk:ih:engctl:solenoid_switch_3_by_sifty.jpg?direct&300|}}| | ||
\\ | \\ |