Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:engctl03a [2018/03/01 23:09] hippysmack [1968 Kicker Cover Roll Pin Repair] |
techtalk:ih:engctl03a [2018/03/02 19:17] hippysmack [1968 Kicker Cover Roll Pin Repair] |
||
---|---|---|---|
Line 19: | Line 19: | ||
* Hardened drywall screw to yank on = screw too big / pin too hard for softer screws. | * Hardened drywall screw to yank on = screw too big / pin too hard for softer screws. | ||
* Try annealing pin to allow drilling = maybe a jeweler's torch setup would be good for this. | * Try annealing pin to allow drilling = maybe a jeweler's torch setup would be good for this. | ||
- | * Other trial methods might include a long drill bit to go through the center of the roll pin and out the bottom. ((brucstoudt of the XLFORUM http://xlforum.net/vbportal/forums/showthread.php?t=2061986&page=2)) | + | * Other trial methods might include: |
+ | * A long drill bit to go through the center of the roll pin and out the bottom. ((brucstoudt of the XLFORUM http://xlforum.net/vbportal/forums/showthread.php?t=2061986&page=2)) | ||
+ | * A left handed drill bit ((MXHD55U of the XLFORUM http://xlforum.net/vbportal/forums/showthread.php?postid=5650610#post5650610)) | ||