Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:engmech01 [2018/09/08 02:04] hippysmack |
techtalk:ih:engmech01 [2019/06/16 02:25] hippysmack [Gearcase / Cam Cover] |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ===== Sub-Documents ===== | ===== Sub-Documents ===== | ||
| * [[techtalk:ih:engmech01a|Sprocket Cover Dowel Hole (Case) Repair]] | * [[techtalk:ih:engmech01a|Sprocket Cover Dowel Hole (Case) Repair]] | ||
| - | * [[techtalk:ih:engmech01b|Drain Plugs Explained]] | + | * [[techtalk:ref:oil01#sportster_drain_plugs_explained|Sportster Drain Plugs Explained]] |
| * [[techtalk:ref:engmech01e|Installing a Helicoil on a Drain Plug with the Engine in the Frame]] | * [[techtalk:ref:engmech01e|Installing a Helicoil on a Drain Plug with the Engine in the Frame]] | ||
| + | ===== Gearcase / Cam Cover ===== | ||
| + | |||
| + | | Cam Cover (casting 25202-52A) ((photo by ironheadjunkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=1421916&page=2)) | | ||
| + | |{{:techtalk:ih:engmech:cam_cover_1_25202-52a_by_ironheadjunkie.jpg?direct&300|}}| | ||
| ====== Flywheel ====== | ====== Flywheel ====== | ||
| ===== Sub-Documents ===== | ===== Sub-Documents ===== | ||
| Line 15: | Line 19: | ||
| - | * In May of 1981, the MoCo issued a bulletin stating that product and quality improvements have brought about a commonized flywheel taper design. All tapers have were communized at 6° and all keyways were standardized. In June of 1981, an update to this bulletin was issued to include part numbers. ((HD Service Bulletin #M-829 dated May 19, 1981)) ((HD Service Bulletin #M-829A dated June 12, 1981)) | + | * In May of 1981, the MoCo issued a bulletin stating that product and quality improvements have brought about a commonized flywheel taper design. \\ |
| + | All tapers were communized at 6° and all keyways were standardized. \\ | ||
| + | In June of 1981, an update to this bulletin was issued to include part numbers. ((HD Service Bulletin #M-829 dated May 19, 1981)) ((HD Service Bulletin #M-829A dated June 12, 1981)) | ||
| * A limited number of E1982 XL engines (782216009-782237017) were assembled without the communized flywheel taper design. ((HD Service Bulletin #M-840 dated October 2, 1981)) | * A limited number of E1982 XL engines (782216009-782237017) were assembled without the communized flywheel taper design. ((HD Service Bulletin #M-840 dated October 2, 1981)) | ||
| * Notable component changes are included in the chart below. | * Notable component changes are included in the chart below. | ||
