Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
techtalk:ih:engmech02 [2023/04/17 21:44] hippysmack [1957-1976 gear] |
techtalk:ih:engmech02 [2023/04/17 21:44] hippysmack [1957-1976 gear] |
||
---|---|---|---|
Line 148: | Line 148: | ||
===== Pinion Gear Fit on Shaft ===== | ===== Pinion Gear Fit on Shaft ===== | ||
==== 1957-1976 gear ==== | ==== 1957-1976 gear ==== | ||
- | These are OD measurements of 3 OEM pinion shafts as measured by needspeed (.7844", .7840" and .7840"). \\ | + | These are OD measurements of 3 OEM pinion shafts as measured by needspeed (.7844", .7840" and .7840"). ((http://xlforum.net/forums/showthread.php?p=5991474#post5991474)) \\ |
Comments by Dr Dick; \\ | Comments by Dr Dick; \\ | ||
Installing a tight gear: If you tap the gear on the shaft you are tapping on your flywheel assembly in a direction not supported by anything. NOT recommended. \\ | Installing a tight gear: If you tap the gear on the shaft you are tapping on your flywheel assembly in a direction not supported by anything. NOT recommended. \\ |