Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:engmech03 [2019/06/12 03:09] hippysmack [57-69 models] |
techtalk:ih:engmech03 [2019/06/12 03:11] hippysmack [79-85 models] |
||
---|---|---|---|
Line 141: | Line 141: | ||
**Motorcycles using rod bearings with steel retainers**: \\ | **Motorcycles using rod bearings with steel retainers**: \\ | ||
Check rods for (up and down) play as well as (upper end side shake or rod tip) with the pistons removed from the rods. \\ | Check rods for (up and down) play as well as (upper end side shake or rod tip) with the pistons removed from the rods. \\ | ||
- | Side shake measurement can be done with a ruler using the outside edge of the case as a base line. \\ | ||
When appreciable up and down play is found and side shake at the extreme upper end of the rod is more than the following specs; \\ | When appreciable up and down play is found and side shake at the extreme upper end of the rod is more than the following specs; \\ | ||
The lower bearing should be re-fitted. \\ | The lower bearing should be re-fitted. \\ | ||
Line 160: | Line 159: | ||
==== 79-85 models ==== | ==== 79-85 models ==== | ||
Check rods for up and down play in lower bearings. ((1979-1985 HD FSM (99484-85) pg 3-25)) \\ | Check rods for up and down play in lower bearings. ((1979-1985 HD FSM (99484-85) pg 3-25)) \\ | ||
+ | Measuring side shake is no longer recommended in the FSM as in above. \\ | ||
When up and down play is detected, the lower bearing should be refitted. \\ | When up and down play is detected, the lower bearing should be refitted. \\ | ||
\\ | \\ | ||
[[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] |