Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
techtalk:ih:engmech03 [2019/06/12 03:09] hippysmack [57-69 models] |
techtalk:ih:engmech03 [2019/12/09 16:58] hippysmack [Aftermarket Head Gaskets] |
||
|---|---|---|---|
| Line 43: | Line 43: | ||
| |{{:techtalk:ih:engmech:1969_heads_by_monte03.jpg?direct&400|}}| | |{{:techtalk:ih:engmech:1969_heads_by_monte03.jpg?direct&400|}}| | ||
| | 1969 Iron Heads ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=166440&page=6)) | | | 1969 Iron Heads ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=166440&page=6)) | | ||
| + | |||
| + | |||
| ====== Valves ====== | ====== Valves ====== | ||
| Line 141: | Line 143: | ||
| **Motorcycles using rod bearings with steel retainers**: \\ | **Motorcycles using rod bearings with steel retainers**: \\ | ||
| Check rods for (up and down) play as well as (upper end side shake or rod tip) with the pistons removed from the rods. \\ | Check rods for (up and down) play as well as (upper end side shake or rod tip) with the pistons removed from the rods. \\ | ||
| - | Side shake measurement can be done with a ruler using the outside edge of the case as a base line. \\ | ||
| When appreciable up and down play is found and side shake at the extreme upper end of the rod is more than the following specs; \\ | When appreciable up and down play is found and side shake at the extreme upper end of the rod is more than the following specs; \\ | ||
| The lower bearing should be re-fitted. \\ | The lower bearing should be re-fitted. \\ | ||
| Line 160: | Line 161: | ||
| ==== 79-85 models ==== | ==== 79-85 models ==== | ||
| Check rods for up and down play in lower bearings. ((1979-1985 HD FSM (99484-85) pg 3-25)) \\ | Check rods for up and down play in lower bearings. ((1979-1985 HD FSM (99484-85) pg 3-25)) \\ | ||
| + | Measuring side shake is no longer recommended in the FSM as in above. \\ | ||
| When up and down play is detected, the lower bearing should be refitted. \\ | When up and down play is detected, the lower bearing should be refitted. \\ | ||
| \\ | \\ | ||
| [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | ||
