Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:engmech03 [2019/06/12 03:10] hippysmack [76 and earlier models] |
techtalk:ih:engmech03 [2019/12/09 16:15] hippysmack [Pics of Heads] |
||
|---|---|---|---|
| Line 44: | Line 44: | ||
| | 1969 Iron Heads ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=166440&page=6)) | | | 1969 Iron Heads ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=166440&page=6)) | | ||
| + | ===== Aftermarket Head Gaskets ===== | ||
| + | Cometic MLS head gasket torque: | ||
| + | There are six torque values in sequence: 9-14-22-35-42-42 (all in ft/lb) \\ | ||
| ====== Valves ====== | ====== Valves ====== | ||
| ===== Sub-Documents ===== | ===== Sub-Documents ===== | ||
| Line 159: | Line 162: | ||
| ==== 79-85 models ==== | ==== 79-85 models ==== | ||
| Check rods for up and down play in lower bearings. ((1979-1985 HD FSM (99484-85) pg 3-25)) \\ | Check rods for up and down play in lower bearings. ((1979-1985 HD FSM (99484-85) pg 3-25)) \\ | ||
| + | Measuring side shake is no longer recommended in the FSM as in above. \\ | ||
| When up and down play is detected, the lower bearing should be refitted. \\ | When up and down play is detected, the lower bearing should be refitted. \\ | ||
| \\ | \\ | ||
| [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{:techtalk:gototechnicalmenu.jpg|}}]] | ||
