Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:engmech04 [2021/11/05 23:17] hippysmack [Pushrod Tubes] |
techtalk:ih:engmech04 [2021/11/05 23:31] hippysmack [Pushrod Tubes] |
||
---|---|---|---|
Line 45: | Line 45: | ||
====== Pushrod Tubes ====== | ====== Pushrod Tubes ====== | ||
- | **Pushrod tube orientation by Dr Dick** ((http://xlforum.net/forums/showpost.php?p=3855693&postcount=11)) \\ | + | ===== Pushrod Tube Orientation ===== |
+ | The 1959-1969 Service manual has an (errored) illustration of the pushrod tube assembly. \\ | ||
+ | The illustration shows the bottom tube upside down with the flared end facing the tappet block. \\ | ||
+ | This is incorrect and has been corrected in the 1970-1978 as well as the 1979-1985 service manuals. \\ | ||
+ | The flat end goes down and the flared end goes up. \\ | ||
+ | |||
+ | And here is why. (Pushrod tube orientation by Dr Dick) ((http://xlforum.net/forums/showpost.php?p=3855693&postcount=11)) \\ | ||
Pushrod tubes seal in 3 places. 2 of those, the upper and lower corks, seal on their flat faces. \\ | Pushrod tubes seal in 3 places. 2 of those, the upper and lower corks, seal on their flat faces. \\ | ||
Now think about the center cork. What does it seal? \\ | Now think about the center cork. What does it seal? \\ |