Differences

This shows you the differences between two versions of the page.

--- techtalk:ih:engmech04a [2019/06/14 18:48]
hippysmack [General Process Of Splitting the Rocker Box]
+++ techtalk:ih:engmech04a [2019/06/14 18:53]
hippysmack [Other Split Rocker Box Pics]
@@ Line 72: / Line 72: @@
 ====== General Process Of Splitting the Rocker Box ======
-These are Shovelhead rocker boxes but the process is about the same. \\
+These are Shovelhead rocker boxes but the process is about the same. ((hoosier xlc of the XLFORUM http://xlforum.net/forums/showthread.php?t=130964)) \\
+The center portion where the front bolt goes was left on below to help give support once the pushrods are adjusted. \\
+(in an attempt to help eliminate the chance of a leak).
 First start off with a good set of boxes. Spray a little layout die on them and lay them out for a reference line. ((photos by hoosier xlc of the XLFORUM http://xlforum.net/forums/showthread.php?t=130964)) \\
@@ Line 119: / Line 121: @@
 ====== Other Split Rocker Box Pics ======
-|  75 XLH ((photo by fdny37 of the XLFORUM http://xlforum.net/forums/showthread.php?t=120623))  |
+|  75 XLH ((photo by fdny37 of the XLFORUM http://xlforum.net/forums/showthread.php?t=120623)) \\ These were split for the dual plug setup. ((photo by fdny37 of the XLFORUM http://xlforum.net/forums/showthread.php?t=130964&page=2))  |
 |{{:techtalk:ih:engmech:75_xlh_w_split_rocker_boxes_by_fdny37.jpg?direct&300|}}|

Trace: