Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil03 [2019/12/04 00:27] hippysmack [Sub Documents] |
techtalk:ih:oil03 [2019/12/04 00:27] hippysmack [Sub Documents] |
||
---|---|---|---|
Line 15: | Line 15: | ||
* **Oil Pump Comparisons**: | * **Oil Pump Comparisons**: | ||
* [[techtalk:ref:oil06|Comparing the 77 Style Oil Pump to Newer Pumps]] | * [[techtalk:ref:oil06|Comparing the 77 Style Oil Pump to Newer Pumps]] | ||
- | |||
- | |||
- | |||
On some pump casting bodies you may see an Allen plug in the back of the pump. ((Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=563241)) \\ | On some pump casting bodies you may see an Allen plug in the back of the pump. ((Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=563241)) \\ | ||
Line 23: | Line 20: | ||
In 1972 and with the birth of the 1000cc engine, the pump numbers were -72. \\ | In 1972 and with the birth of the 1000cc engine, the pump numbers were -72. \\ | ||
It had larger gears and a bigger breather slot. \\ | It had larger gears and a bigger breather slot. \\ | ||
- | ** | ||
- | Some pump gear data from kitabel**: ((kitabel of the XLFORUM http://xlforum.net/forums/showthread.php?p=5792413#post5792413)) \\ | + | **Some pump gear data from kitabel**: ((kitabel of the XLFORUM http://xlforum.net/forums/showthread.php?p=5792413#post5792413)) \\ |
The pitch distance of 14 & 16 tooth pumps is not the same. \\ | The pitch distance of 14 & 16 tooth pumps is not the same. \\ | ||
All driven and idler gears have .422" ID center holes. \\ | All driven and idler gears have .422" ID center holes. \\ |