Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:oil03 [2019/12/04 00:27] hippysmack [Sub Documents] |
techtalk:ih:oil03 [2019/12/19 04:40] hippysmack [Sub Documents] |
||
---|---|---|---|
Line 15: | Line 15: | ||
* **Oil Pump Comparisons**: | * **Oil Pump Comparisons**: | ||
* [[techtalk:ref:oil06|Comparing the 77 Style Oil Pump to Newer Pumps]] | * [[techtalk:ref:oil06|Comparing the 77 Style Oil Pump to Newer Pumps]] | ||
- | |||
- | |||
- | |||
On some pump casting bodies you may see an Allen plug in the back of the pump. ((Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=563241)) \\ | On some pump casting bodies you may see an Allen plug in the back of the pump. ((Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=563241)) \\ | ||
Line 23: | Line 20: | ||
In 1972 and with the birth of the 1000cc engine, the pump numbers were -72. \\ | In 1972 and with the birth of the 1000cc engine, the pump numbers were -72. \\ | ||
It had larger gears and a bigger breather slot. \\ | It had larger gears and a bigger breather slot. \\ | ||
- | ** | ||
- | Some pump gear data from kitabel**: ((kitabel of the XLFORUM http://xlforum.net/forums/showthread.php?p=5792413#post5792413)) \\ | ||
- | The pitch distance of 14 & 16 tooth pumps is not the same. \\ | ||
- | All driven and idler gears have .422" ID center holes. \\ | ||
- | 14 tooth gears (1952-61) are .970" OD. \\ | ||
- | All feed gears are .217" thick. \\ | ||
- | All return gears are .360" thick. \\ | ||
- | 16 tooth gears (1962-76, also all 45 & UL return pumps) are 1.115" OD. \\ | ||
- | 1962-71 feed are .185" thick. \\ | ||
- | 1962-71 return .375" thick. \\ | ||
- | 1972-76 return .398" thick. \\ | ||
- | 45 & UL 1937-73 return .315" thick. \\ | ||
- | Inspect your spares and purchases carefully - 1936-* OHV BT gears are 14 tooth, but .990" OD and only the driven gears have .422" ID hole (the idlers are .342"). \\ | ||
====== XR-750 Oil Pumps (only) ====== | ====== XR-750 Oil Pumps (only) ====== |