Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil03e [2018/12/21 19:15] hippysmack [Stuck Cover Gasket] |
techtalk:ih:oil03e [2018/12/21 20:57] hippysmack [Disassembly] |
||
---|---|---|---|
Line 124: | Line 124: | ||
* Two small drivers were used here (1 to keep the ring from spinning, 1 to raise an end out of the groove in the gearshaft). | * Two small drivers were used here (1 to keep the ring from spinning, 1 to raise an end out of the groove in the gearshaft). | ||
- | * The 1st screwdriver can be pushed into the slot in the gerotor to keep the ring from spinning. | + | * The 1st screwdriver can be pushed into the slot in the gerotor to keep the ring from spinning. |
- | * This will allow you to pick and out on one end and then switch back and forth between the two from there. | + | * This will allow you to pick and out on one end and then switch back and forth between the two from there. |
+ | * Remove the retainer clip. | ||
+ | * Then pull out the inner plate. | ||
|{{:techtalk:ih:oil:77-e83_oil_pump_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ih:oil:77-e83_oil_pump_5_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ih:oil:77-e83_oil_pump_6_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ih:oil:77-e83_oil_pump_7_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ih:oil:77-e83_oil_pump_5_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ih:oil:77-e83_oil_pump_6_by_hippysmack.jpg?direct&300|}}| |