Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ih:oil03g [2019/12/21 04:01] hippysmack [Shaft Seal Repair] |
techtalk:ih:oil03g [2019/12/21 04:28] hippysmack [Check Ball Seat Repair] |
||
---|---|---|---|
Line 76: | Line 76: | ||
The seat can be lapped with a clean bead blasted Evo pushrod end (it’s the same size as | The seat can be lapped with a clean bead blasted Evo pushrod end (it’s the same size as | ||
the check ball). ((gungatim of the XLFORUM http://xlforum.net/forums/showthread.php?t=1013445)) \\ | the check ball). ((gungatim of the XLFORUM http://xlforum.net/forums/showthread.php?t=1013445)) \\ | ||
+ | Basically you are reconditioning the seat where the ball sits so it creates a good seal around the ball. \\ | ||
The tool on the left is a homemade check ball lapping tool used to lap the seat where the check ball sits in the oil pump (57-76). ((Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool)) \\ | The tool on the left is a homemade check ball lapping tool used to lap the seat where the check ball sits in the oil pump (57-76). ((Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool)) \\ |