Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ih:oil03g [2019/12/21 04:01] hippysmack [Shaft Seal Repair] |
techtalk:ih:oil03g [2021/02/17 23:27] hippysmack [Leaking Around Oil Pressure Switch Connection] |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| * [[https://www.youtube.com/watch?v=Ry1ZsiVfPJI|Youtube video on an oil feed seal]]. Far easier and non destructive. ((video by bustert of the XLFORUM)) | * [[https://www.youtube.com/watch?v=Ry1ZsiVfPJI|Youtube video on an oil feed seal]]. Far easier and non destructive. ((video by bustert of the XLFORUM)) | ||
| + | ====== Leaking Around Oil Pressure Switch Connection====== | ||
| + | {{:techtalk:ih:oil:77-85_sportster_oil_pump_cracked_by_canadiantux.jpg?direct&300|}} ((photo by CanadianTux of the XLFORUM)) \\ | ||
| ====== Fixing Leaky Pump from Sit Sumping ====== | ====== Fixing Leaky Pump from Sit Sumping ====== | ||
| Oil getting into the crankcase from the act of the bike just sitting still is a common occurrence. ((Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1813185&page=2 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1813185&page=2)) \\ | Oil getting into the crankcase from the act of the bike just sitting still is a common occurrence. ((Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1813185&page=2 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1813185&page=2)) \\ | ||
| Line 76: | Line 78: | ||
| The seat can be lapped with a clean bead blasted Evo pushrod end (it’s the same size as | The seat can be lapped with a clean bead blasted Evo pushrod end (it’s the same size as | ||
| the check ball). ((gungatim of the XLFORUM http://xlforum.net/forums/showthread.php?t=1013445)) \\ | the check ball). ((gungatim of the XLFORUM http://xlforum.net/forums/showthread.php?t=1013445)) \\ | ||
| + | Basically you are reconditioning the seat where the ball sits so it creates a good seal around the ball. \\ | ||
| The tool on the left is a homemade check ball lapping tool used to lap the seat where the check ball sits in the oil pump (57-76). ((Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool)) \\ | The tool on the left is a homemade check ball lapping tool used to lap the seat where the check ball sits in the oil pump (57-76). ((Toolmaker of the XLFORUM http://xlforum.net/forums/showthread.php?t=499487&highlight=check+ball+lapping+tool)) \\ | ||
