Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
techtalk:ih:oil04a [2019/06/27 16:58]
hippysmack created
techtalk:ih:oil04a [2021/03/02 18:42]
hippysmack removed
Line 2: Line 2:
 ====== IH: Oiling & Lubrication - Sub-04A ====== ====== IH: Oiling & Lubrication - Sub-04A ======
 ====== Rebuilding the Kidney Tank Oil Cap ====== ====== Rebuilding the Kidney Tank Oil Cap ======
 +These pics show how the oil cap comes apart. \\
 +Here is what you have when you flip it over and clean it up. \\
 +
 +With the C-clip removed, hold the round end that the dipstick comes out of. \\
 +Turn the wing nut counter clockwise to unscrew it from the rest of the assembly. \\
 +The lower section will slide to the side and then lift out one side at a time. \\ 
 +This is not necessary to replace the gasket or the O-ring but it may be for something more in depth. \\
 +
 +|Right against the cap you have a C-clip. Pull it out.|  Unscrew the dipstick from the cap.  ||
 +|{{:​techtalk:​ih:​oil:​rebuilding_the_kidney_tank_oil_cap_1_by_shameless.jpg?​direct&​300|}}|{{:​techtalk:​ih:​oil:​rebuilding_the_kidney_tank_oil_cap_2_by_shameless.jpg?​direct&​300|}}|{{:​techtalk:​ih:​oil:​rebuilding_the_kidney_tank_oil_cap_3_by_shameless.jpg?​direct&​300|}}|
 +
 +There is an O-ring at the top of the shaft between the cap and the wing nut. \\
 +If it's flattened, it may cause an oil leak on the top of my tank. \\
 +
 +|Check the O-ring.|This one was replaced with one from an Evo head rebuild (bigger O-ring). \\ The inside diameter was a little big but it fit inside the groove and was thick enough to seat against the cap.||
 +|{{:​techtalk:​ih:​oil:​rebuilding_the_kidney_tank_oil_cap_4_by_shameless.jpg?​direct&​300|}}|{{:​techtalk:​ih:​oil:​rebuilding_the_kidney_tank_oil_cap_5_by_shameless.jpg?​direct&​300|}}|{{:​techtalk:​ih:​oil:​rebuilding_the_kidney_tank_oil_cap_6_by_shameless.jpg?​direct&​300|}}|
 +