Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| techtalk:ih:priclutch02f [2024/12/24 16:37] – [Installing Primary Chain Tensioner Upgrade Kit on 1977-E1980 Sportsters] hippysmack | techtalk:ih:priclutch02f [2024/12/24 18:53] (current) – [Installing Primary Chain Tensioner Upgrade Kit on 1977-E1980 Sportsters] hippysmack | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| In the hardware pic below (R), There are two steel flat washers and two copper washers for the pivot stud, apparently to provide an extra set. There are two steel flat washers for the adjusting stud, one is extra, and no copper washers, so you should get some to avoid leaks. The two nuts on the bottom left are 3/ | In the hardware pic below (R), There are two steel flat washers and two copper washers for the pivot stud, apparently to provide an extra set. There are two steel flat washers for the adjusting stud, one is extra, and no copper washers, so you should get some to avoid leaks. The two nuts on the bottom left are 3/ | ||
| - | Click on any pic to enlarge: ((Fizzle of the XLFORUM)) \\ | + | Click on any pic to enlarge: ((pics by Fizzle of the XLFORUM)) \\ |
| {{: | {{: | ||
| \\ | \\ | ||
| Line 25: | Line 25: | ||
| Here, the pivot stud is pushing the old bolt out while the spring and shoe stay in place.\\ | Here, the pivot stud is pushing the old bolt out while the spring and shoe stay in place.\\ | ||
| - | You can see how the spring is oriented with the cover on. \\ | + | You can see how the spring is oriented with the cover on. The spring should push the pad down against the adjusting screw when installed. \\ |
| - | The spring should push the pad down against the adjusting screw when installed. \\ | + | And it's installed to contour to the pad bracket and the case. \\ |
| + | You can also buy a short piece of 1/ | ||
| + | The cover is app. 1-1/4" thick plus about 1/4" of threading into the case (so cut 4 pieces to app. 2" lengths so you can remove them once the cover is on. \\ | ||
| + | 2" bolts with the heads cut off would also work. \\ | ||
| + | Then just install the studs (2 up, 2 down) with your fingers only, slide the cover over the studs, add bolts elsewhere to hold the cover up and remove the studs. \\ | ||
| + | This helps if you have to check fitment against the gasket and such. \\ | ||
| + | Then toss the studs you made in the toolbox. They can also be used on the cam cover. \\ | ||
| {{: | {{: | ||
| \\ | \\ | ||
| - | Finally, push the end of the spring up so it slides into the case as you push the cover home.\\ | + | Finally, push the end of the spring up so it slides into the case as you push the cover home. \\ |
| The OEM Harley kit came with instructions that advise to check the gasket for clearance and trim it if necessary. I didn't have a problem with this James gasket.\\ | The OEM Harley kit came with instructions that advise to check the gasket for clearance and trim it if necessary. I didn't have a problem with this James gasket.\\ | ||
| {{: | {{: | ||
