Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:susp03 [2017/11/01 01:06] hippysmack [Swingarm (rear fork) Info] |
techtalk:ih:susp03 [2017/11/12 19:19] hippysmack [Swingarm Pivot Bolts, Bearings and Related Parts List] |
||
---|---|---|---|
Line 87: | Line 87: | ||
|54-E74 KH/XL/XLH/XLCH|Bearing Kit 47550-74| 82-85 XL/XLS/XLX|(Right) (2) 47082-81 \\ Timken: Race LM11710, Bearing LM11749 ((GA_Ironhead http://xlforum.net/vbportal/forums/showthread.php?t=709634&page=5))| | |54-E74 KH/XL/XLH/XLCH|Bearing Kit 47550-74| 82-85 XL/XLS/XLX|(Right) (2) 47082-81 \\ Timken: Race LM11710, Bearing LM11749 ((GA_Ironhead http://xlforum.net/vbportal/forums/showthread.php?t=709634&page=5))| | ||
|L74-81 XLH/XLCH/XLS|(2) 47521-74 \\ Timken: Race 11520, Bearing 11590 ((GA_Ironhead http://xlforum.net/vbportal/forums/showthread.php?t=709634&page=5))| | |L74-81 XLH/XLCH/XLS|(2) 47521-74 \\ Timken: Race 11520, Bearing 11590 ((GA_Ironhead http://xlforum.net/vbportal/forums/showthread.php?t=709634&page=5))| | ||
+ | |||
+ | * Bearing Kit (47550-74) (replaced the single bearing part # 47521-52) contains 2 bearings which are 0.100" narrower than the original bearing dims used in Sportsters up to February of 1974. The kit also contains a new pivot bolt nut (47512-74), bearing locknuts (L - 47514-74, R - 47515-74) and an outer spacer (47521-74) - clearanced for the new bearings. ((HD Service Bulletin #688 dated May 12, 1974)) | ||