Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:ih:susp03 [2018/04/18 01:08] ixl2relax |
techtalk:ih:susp03 [2022/02/12 05:08] hippysmack |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== Swingarm (rear fork) Info ====== | ====== Swingarm (rear fork) Info ====== | ||
| + | ===== Sub Documents ===== | ||
| + | * [[techtalk:ih:susp03a|1957-1985 Swingarm Pics and Information]] | ||
| + | |||
| A number of 1972 Sportsters were produced from November 1, 1971 to March 29, 1972 without the (3 position) stake operation performed on the rear left side fork bearing lock nut (47514-52). Bearing pre-load (which should be kept at 1-2 pounds) is controlled by the left and right (47515-52) bearing lock nuts. The affected VINs were (3A or 4A) 18748H2 to 33040H2. This safety defect prompted a recall of the affected bikes with the dealer being required to remove the rear fork for inspection and stake any of them that were done previously at a rate of $7 reimbursed labor and handling. ((HD Service Bulletin #636 dated April 27, 1972 pg OC-403)) | A number of 1972 Sportsters were produced from November 1, 1971 to March 29, 1972 without the (3 position) stake operation performed on the rear left side fork bearing lock nut (47514-52). Bearing pre-load (which should be kept at 1-2 pounds) is controlled by the left and right (47515-52) bearing lock nuts. The affected VINs were (3A or 4A) 18748H2 to 33040H2. This safety defect prompted a recall of the affected bikes with the dealer being required to remove the rear fork for inspection and stake any of them that were done previously at a rate of $7 reimbursed labor and handling. ((HD Service Bulletin #636 dated April 27, 1972 pg OC-403)) | ||
