Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ih:trouble01 [2017/07/18 15:59] hippysmack [Installing your Iron Head Engine] |
techtalk:ih:trouble01 [2017/07/18 16:03] hippysmack [Installing your Iron Head Engine] |
||
---|---|---|---|
Line 22: | Line 22: | ||
===== Installing your Iron Head Engine ===== | ===== Installing your Iron Head Engine ===== | ||
- | Let's break the mount install into two procedures. | + | Let's break the mount install into two procedures. ((DR DICK of the XLFORUM http://xlforum.net/vbportal/forums/showthread.php?t=1864035&highlight=Ironhead+Crankcase+Drain+Plug&page=4)) |
- **Mount to Frame**. You see that the mount has a machined surf that sets an a machined shelf on frame. That interface is what sets the mount 'square' to frame. | - **Mount to Frame**. You see that the mount has a machined surf that sets an a machined shelf on frame. That interface is what sets the mount 'square' to frame. | ||
Line 38: | Line 38: | ||
Make sense so far? \\ The below procedure get's done on the bench previous to motor install. | Make sense so far? \\ The below procedure get's done on the bench previous to motor install. | ||
- | * 2 **Mount to motor** | + | * 2. **Mount to motor** |
* 7 fasteners, three studs/nuts, 2 bolts with lock washers, and two oil tank stand-off with lockwashers. | * 7 fasteners, three studs/nuts, 2 bolts with lock washers, and two oil tank stand-off with lockwashers. | ||
* Slip mount in place and reinstall the 3 studs then remove/loosen nuts so mount is free on studs. | * Slip mount in place and reinstall the 3 studs then remove/loosen nuts so mount is free on studs. |