Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
techtalk:ih:wheels01 [2020/03/19 15:25]
hippysmack [Factory Wheels Pics]
techtalk:ih:wheels01 [2020/06/27 04:52]
hippysmack ↷ Links adapted because of a move operation
Line 28: Line 28:
 ====== Wheel Hub ====== ====== Wheel Hub ======
  
-  * {{ :pdf:​rim-hub_dimension_chart.pdf |Rim / Hub Dimension Chart - PDF}}+  * {{ pdf-bulletin:​rim-hub_dimension_chart.pdf |Rim / Hub Dimension Chart - PDF}}
  
 |**Front & Rear Hubs (by year and part number)**||||| |**Front & Rear Hubs (by year and part number)**|||||
Line 172: Line 172:
 ===== Measuring / Sizing Wheel Hub Spacers ===== ===== Measuring / Sizing Wheel Hub Spacers =====
  
-  * If your unsure of which hub spacer you need , the best way to find out is to mock up your wheel / hub and do some measuring: ((rivethog of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1638639&​page=2))+  * If your unsure of which hub spacer you need , the best way to find out is to mock up your wheel / hub and do some measuring: ((rivethog of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1638639&​page=2)) \\ Wheel bearing endplay should be.004"​-.018"​ with the axle nut torqued to 60-70 ft/lbs. ((1979-1985 Sportster FSM pgs 2-9,  2-15))
   - Install outer races into the hub, make sure they'​re fully seated. Don't install any seals yet.   - Install outer races into the hub, make sure they'​re fully seated. Don't install any seals yet.
   - Clamp the axle in a vise vertically, threaded end up.   - Clamp the axle in a vise vertically, threaded end up.