Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
techtalk:menu [2021/07/09 04:57] hippysmack [Reference Technical Categories] |
techtalk:menu [2021/07/10 01:00] hippysmack [Reference Technical Categories] |
||
|---|---|---|---|
| Line 337: | Line 337: | ||
| * [[techtalk:ref:tools026|Torque Wrench Field Calibration]] | * [[techtalk:ref:tools026|Torque Wrench Field Calibration]] | ||
| * [[techtalk:ref:tools030|General Drilling and Tapping]] | * [[techtalk:ref:tools030|General Drilling and Tapping]] | ||
| - | * [[techtalk:ref:tools031|Decimal Equivalent Chart]] | + | * [[techtalk:ref:tools031|Decimal Equivalent Chart]] (Fraction, wire gauge, letter and metric sizes) |
| - | * (Fraction, wire gauge, letter and metric sizes) | + | |
| * [[techtalk:ref:tools032|Thread Identification and Sizing Charts]] | * [[techtalk:ref:tools032|Thread Identification and Sizing Charts]] | ||
| * [[techtalk:ref:tools035|Retaining Ring Sizing Charts]] | * [[techtalk:ref:tools035|Retaining Ring Sizing Charts]] | ||
| + | * [[techtalk:ref:tools038|Press Fit Bushing in Bore Charts]] | ||
| * <font 14px/inherit;;inherit;;inherit>**Engine Conversions**</font> | * <font 14px/inherit;;inherit;;inherit>**Engine Conversions**</font> | ||
