Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:body01i [2019/07/03 23:24]
hippysmack [Using a Fabbed Extension Plate]
techtalk:ref:body01i [2019/07/03 23:40] (current)
hippysmack [Modding Dyna Highway Peg Brackets]
Line 11: Line 11:
  
 ===== Modding Dyna Highway Peg Brackets ===== ===== Modding Dyna Highway Peg Brackets =====
 +In order to accomplish this mod, you need to have pipes that do not obstruct the front frame area. ((Paulie420 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=39020&​highlight=forward+controls)) \\
 +There is a 3" extension piece on either side of the frame connected at the original foot peg position. \\
 +Then, there is a horizontal piece welded in between those two extensions for strength. \\
 +This solves two things; putting the controls 3" out and 1/4" - 1/2" up. \\
  
 +Then, you have to deal with the brake bar. \\
 +Since the pegs are now 3" forward, it won't fit or the brake pedal would be underneath the peg. \\
 +The one below was cut and 3" of steel was welded in the middle then heat wrap was installed over the whole bar. \\
 +
 +On the shifter side, a long chrome bar was cut to length and re-threaded for a linkage. ((photos by Paulie420 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=39020&​highlight=forward+controls)) \\
 +
 +|{{:​techtalk:​ref:​body:​extended_forwards_1_by_paulie420.jpg?​direct&​300|}}|
 +
 +|{{:​techtalk:​ref:​body:​extended_forwards_2_by_paulie420.jpg?​direct&​300|}}|{{:​techtalk:​ref:​body:​extended_forwards_3_by_paulie420.jpg?​direct&​300|}}|{{:​techtalk:​ref:​body:​extended_forwards_4_by_paulie420.jpg?​direct&​300|}}|
 ====== 03 and Prior Models ====== ====== 03 and Prior Models ======
 ===== JayBrake ===== ===== JayBrake =====