Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:body30i [2019/07/03 23:24] hippysmack [Using a Fabbed Extension Plate] |
techtalk:ref:body30i [2019/07/03 23:40] hippysmack [Modding Dyna Highway Peg Brackets] |
||
---|---|---|---|
Line 11: | Line 11: | ||
===== Modding Dyna Highway Peg Brackets ===== | ===== Modding Dyna Highway Peg Brackets ===== | ||
+ | In order to accomplish this mod, you need to have pipes that do not obstruct the front frame area. ((Paulie420 of the XLFORUM http://xlforum.net/forums/showthread.php?t=39020&highlight=forward+controls)) \\ | ||
+ | There is a 3" extension piece on either side of the frame connected at the original foot peg position. \\ | ||
+ | Then, there is a horizontal piece welded in between those two extensions for strength. \\ | ||
+ | This solves two things; putting the controls 3" out and 1/4" - 1/2" up. \\ | ||
+ | Then, you have to deal with the brake bar. \\ | ||
+ | Since the pegs are now 3" forward, it won't fit or the brake pedal would be underneath the peg. \\ | ||
+ | The one below was cut and 3" of steel was welded in the middle then heat wrap was installed over the whole bar. \\ | ||
+ | |||
+ | On the shifter side, a long chrome bar was cut to length and re-threaded for a linkage. ((photos by Paulie420 of the XLFORUM http://xlforum.net/forums/showthread.php?t=39020&highlight=forward+controls)) \\ | ||
+ | |||
+ | |{{:techtalk:ref:body:extended_forwards_1_by_paulie420.jpg?direct&300|}}| | ||
+ | |||
+ | |{{:techtalk:ref:body:extended_forwards_2_by_paulie420.jpg?direct&300|}}|{{:techtalk:ref:body:extended_forwards_3_by_paulie420.jpg?direct&300|}}|{{:techtalk:ref:body:extended_forwards_4_by_paulie420.jpg?direct&300|}}| | ||
====== 03 and Prior Models ====== | ====== 03 and Prior Models ====== | ||
===== JayBrake ===== | ===== JayBrake ===== |