Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
techtalk:ref:body30r [2019/06/16 21:09] hippysmack [Spacer for the Shifter linkage] |
techtalk:ref:body30r [2022/03/09 05:02] ixl2relax [REF: Body Parts - Sub-01R] |
||
---|---|---|---|
Line 1: | Line 1: | ||
[[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | [[:techtalk:menu|{{ :techtalk:gototechnicalmenu.jpg|}}]] | ||
- | ====== REF: Body Parts - Sub-01R ====== | + | ====== REF: Body Parts - Sub-30R ====== |
====== Linkage Mods ====== | ====== Linkage Mods ====== | ||
====== Gun Barrel Spacer for the Shifter linkage ====== | ====== Gun Barrel Spacer for the Shifter linkage ====== | ||
Here is a muzzle loading rifle barrel that was drilled, then a bronze sleeve was inserted to hook up the \\ shifter linkage when forwards were installed on a 1979 Roadster ((photo by sltm1 of the XLFORUM http://xlforum.net/forums/showthread.php?threadid=2046745)) | Here is a muzzle loading rifle barrel that was drilled, then a bronze sleeve was inserted to hook up the \\ shifter linkage when forwards were installed on a 1979 Roadster ((photo by sltm1 of the XLFORUM http://xlforum.net/forums/showthread.php?threadid=2046745)) | ||
- | |{{:techtalk:ih:body:gun_barrel_spacer_for_forwards_on_79_roadster_by_sltm1.jpg?direct&400|}}| | + | |{{techtalk:ref:body:gun_barrel_spacer_for_forwards_on_79_roadster_by_sltm1.jpg?direct&300|}}| |
+ | |||
+ | ====== Make Your Own Shifter Link ====== | ||
+ | Here is a shifter link made from (304) stainless steel. ((Folkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=286387)) ((http://xlforum.net/forums/showthread.php?t=286387&page=3)) \\ | ||
+ | You can cut the threads by hand (or even better on a lathe). \\ | ||
+ | Be sure to buy more length than you need to practice on. \\ | ||
+ | Stainless is not easy to thread, especially by hand. \\ | ||
+ | If you're going to cut threads in stainless steel, even the 'free machining' 303 grade, you want some fairly good quality dies. \\ | ||
+ | |||
+ | | Homemade stainless steel shifter linkage. ((Folkie of the XLFORUM http://xlforum.net/forums/showthread.php?t=286387)) ||| | ||
+ | |{{:techtalk:ref:body:stainless_shifter_linkage_3_by_folkie.jpg?direct&300|}}|{{:techtalk:ref:body:stainless_shifter_linkage_1_by_folkie.jpg?direct&300|}}|{{:techtalk:ref:body:stainless_shifter_linkage_2_by_folkie.jpg?direct&300|}}| | ||
\\ | \\ |