Table of Contents
This is an old revision of the document!
REF: Body Parts
Tool Bags
Downtube Bag
An HD bag:
The bracket with two nuts already welded to the down tubes was used to fasten the bag. 1)
HD downtube bag. 2) | |
9000 series Otter Box:
It's waterproof and small enough to mount on the downtubes.
9000 series Otter Box fastened to the downtubes. 3) | ||
Swingarm Toolbag Mount
The bag sets higher than the exhaust. You'd have to be leaning heavily before that bag will touch the ground.
Making a bracket mount for a leather tool bag. Bracket was made from 1/8“ thick aluminum and some misc chrome hardware. An angle was cut on the front end. 6) | ||
Bracket shaped with a hand file, and holes drilled for mounting to the swingarm. 7) | Holes also drilled to mount the bracket to the bag. 8) | Edges rounded with a file, bracket wet sanded with 320/400/1500 grit paper respectively and then hand polished. 9) |
Final fitting to mark a hole on the rear side at the swingarm. 10) | The hole was then drilled and tapped. 11) | The bag mounting holes in the bracket were partially counter bored to allow clearance between the hardware and swingarm. 12) |
Assembling bracket to bag. 13) | Inside the bag, large flat washers, lock washers and nylocks. 14) | Bag mounted with chrome buttonheads, spacers and Loc-tite. 15) |
If after the bag gets broken in and it sort of flops over, you can add some metal flat stock inside the bag to keep it rigid. 16) |
1)
maurino17 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1666606
2)
photos by maurino17 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1666606
3)
photos by vettelover84 of the XLFORUM http://xlforum.net/forums/showthread.php?p=2119241#post2119241
4)
, 5)
, 7)
, 8)
, 9)
, 10)
, 11)
, 12)
, 13)
, 14)
, 15)
photo by Johnny Wolf of the XLFORUM http://xlforum.net/forums/showthread.php?t=483698
6)
photos by Johnny Wolf of the XLFORUM http://xlforum.net/forums/showthread.php?t=483698
16)
photo by ReddTiger of the XLFORUM http://xlforum.net/forums/showthread.php?t=483698&page=2