Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
techtalk:ref:carb01i [2019/09/08 21:27] hippysmack created |
techtalk:ref:carb01i [2019/11/14 05:49] hippysmack [Main Fuel System] |
||
|---|---|---|---|
| Line 53: | Line 53: | ||
| * The bleed type system is designed to hold air in the body of the needle jet and then to have the air/fuel metered. | * The bleed type system is designed to hold air in the body of the needle jet and then to have the air/fuel metered. | ||
| - | {{:techtalk:ref:carb:vm-38_throttle_opening_diagram_by_hippysmack.jpg?direct&400|}} ((drawing by Hippysmack)) \\ | + | {{:techtalk:ref:carb:1vm-38_throttle_opening_diagram_by_hippysmack.jpg?direct&400|}} ((drawing by Hippysmack)) \\ |
| **Jet needle and needle jet**: \\ | **Jet needle and needle jet**: \\ | ||
| Line 147: | Line 147: | ||
| There is nothing else that could be causing the fast idle unless the slide was truly worn out, and that is not likely on a Mikuni with the heavy brass slide. \\ | There is nothing else that could be causing the fast idle unless the slide was truly worn out, and that is not likely on a Mikuni with the heavy brass slide. \\ | ||
| - | {{:techtalk:ref:carb:vm-38_air_adjustment_screw_by_piniongear.jpg?direct&300|}} ((photo by http://xlforum.net/forums/showthread.php?t=835717 of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) \\ | + | {{:techtalk:ref:carb:vm-38_air_adjustment_screw_by_piniongear.jpg?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) \\ |
| ====== Troubleshooting ====== | ====== Troubleshooting ====== | ||
