Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:carb01i [2019/09/08 21:27] hippysmack created |
techtalk:ref:carb01i [2019/11/14 05:53] hippysmack [Main Fuel System] |
||
---|---|---|---|
Line 59: | Line 59: | ||
The clip on the needle should be in the middle notch. That is third from the top or third from the bottom. \\ | The clip on the needle should be in the middle notch. That is third from the top or third from the bottom. \\ | ||
The needle jet is a 166 Q-2 with a single hole. \\ | The needle jet is a 166 Q-2 with a single hole. \\ | ||
- | {{:techtalk:ref:carb:vm-38_needle_jet_by_piniongear.png?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) {{:techtalk:ref:carb:vm-38_needle_jet_by_jayd241.jpg?direct&300|}} ((photo by jayd241 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1675923&page=2)) {{:techtalk:ref:carb:mikuni_vm_needle_jet_types_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) \\ | + | {{:techtalk:ref:carb:vm-38_needle_jet_by_piniongear.png?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) {{:techtalk:ref:carb:vm-38_needle_jet_by_jayd241.jpg?direct&300|}} ((photo by jayd241 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1675923&page=2)) {{:techtalk:ref:carb:1mikuni_vm_needle_jet_types_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) \\ |
Line 147: | Line 147: | ||
There is nothing else that could be causing the fast idle unless the slide was truly worn out, and that is not likely on a Mikuni with the heavy brass slide. \\ | There is nothing else that could be causing the fast idle unless the slide was truly worn out, and that is not likely on a Mikuni with the heavy brass slide. \\ | ||
- | {{:techtalk:ref:carb:vm-38_air_adjustment_screw_by_piniongear.jpg?direct&300|}} ((photo by http://xlforum.net/forums/showthread.php?t=835717 of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) \\ | + | {{:techtalk:ref:carb:vm-38_air_adjustment_screw_by_piniongear.jpg?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) \\ |
====== Troubleshooting ====== | ====== Troubleshooting ====== |