Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
techtalk:ref:carb01i [2019/11/14 05:53] hippysmack [Main Fuel System] |
techtalk:ref:carb01i [2019/11/14 05:57] hippysmack [Main Fuel System] |
||
---|---|---|---|
Line 59: | Line 59: | ||
The clip on the needle should be in the middle notch. That is third from the top or third from the bottom. \\ | The clip on the needle should be in the middle notch. That is third from the top or third from the bottom. \\ | ||
The needle jet is a 166 Q-2 with a single hole. \\ | The needle jet is a 166 Q-2 with a single hole. \\ | ||
- | {{:techtalk:ref:carb:vm-38_needle_jet_by_piniongear.png?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) {{:techtalk:ref:carb:vm-38_needle_jet_by_jayd241.jpg?direct&300|}} ((photo by jayd241 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1675923&page=2)) {{:techtalk:ref:carb:1mikuni_vm_needle_jet_types_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) \\ | + | {{:techtalk:ref:carb:vm-38_needle_jet_by_piniongear.png?direct&300|}} ((photo by piniongear of the XLFORUM http://xlforum.net/forums/showthread.php?t=835717)) {{:techtalk:ref:carb:vm-38_needle_jet_by_jayd241.jpg?direct&300|}} ((photo by jayd241 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1675923&page=2)) {{:techtalk:ref:carb:mikuni_vm_needle_jet_types_by_hippysmack.jpg?direct&300|}} ((drawing by Hippysmack)) \\ |