Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
techtalk:ref:carb01i [2019/11/14 05:53]
hippysmack [Main Fuel System]
techtalk:ref:carb01i [2019/11/14 05:57] (current)
hippysmack [Main Fuel System]
Line 59: Line 59:
 The clip on the needle should be in the middle notch. That is third from the top or third from the bottom. \\ The clip on the needle should be in the middle notch. That is third from the top or third from the bottom. \\
 The needle jet is a 166 Q-2 with a single hole. \\  The needle jet is a 166 Q-2 with a single hole. \\ 
-{{:​techtalk:​ref:​carb:​vm-38_needle_jet_by_piniongear.png?​direct&​300|}} ((photo by piniongear of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=835717)) {{:​techtalk:​ref:​carb:​vm-38_needle_jet_by_jayd241.jpg?​direct&​300|}} ((photo by jayd241 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1675923&​page=2)) {{:​techtalk:​ref:​carb:​1mikuni_vm_needle_jet_types_by_hippysmack.jpg?​direct&​300|}} ((drawing by Hippysmack)) \\+{{:​techtalk:​ref:​carb:​vm-38_needle_jet_by_piniongear.png?​direct&​300|}} ((photo by piniongear of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=835717)) {{:​techtalk:​ref:​carb:​vm-38_needle_jet_by_jayd241.jpg?​direct&​300|}} ((photo by jayd241 of the XLFORUM http://​xlforum.net/​forums/​showthread.php?​t=1675923&​page=2)) {{:​techtalk:​ref:​carb:​mikuni_vm_needle_jet_types_by_hippysmack.jpg?​direct&​300|}} ((drawing by Hippysmack)) \\