Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:carb01j [2019/09/10 01:09] hippysmack [Throttle Cable] |
techtalk:ref:carb01j [2019/09/10 01:09] hippysmack [Throttle Cable] |
||
---|---|---|---|
Line 127: | Line 127: | ||
The universal cable made by Barnett for this application is Barnett part number 101-31-30901. \\ | The universal cable made by Barnett for this application is Barnett part number 101-31-30901. \\ | ||
It is described as a 38" cable, and is about 4" too long for this bike setup so a new one was made. \\ | It is described as a 38" cable, and is about 4" too long for this bike setup so a new one was made. \\ | ||
- | <blockquote>I do not understand how they calculate cable length but this must be a 34" cable as it is 4" shorter than the 38". | + | <blockquote>I do not understand how they calculate cable length but this must be a 34" cable as it is 4" shorter than the 38". \\ |
Here is the spec diagram for the 4" shorter throttle cable; if you need to get one special made you can use this as a guide.</blockquote> ((IronMick)) \\ | Here is the spec diagram for the 4" shorter throttle cable; if you need to get one special made you can use this as a guide.</blockquote> ((IronMick)) \\ | ||
Note that the two 90° fittings are not the same. The one to the right is for the carb, the one to the left is for the throttle at the handlebar. \\ | Note that the two 90° fittings are not the same. The one to the right is for the carb, the one to the left is for the throttle at the handlebar. \\ |