Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
techtalk:ref:carb01j [2019/09/10 01:09] hippysmack [Throttle Cable] |
techtalk:ref:carb01j [2019/09/16 03:29] hippysmack [Mounting a Mikuni VM-38] |
||
---|---|---|---|
Line 36: | Line 36: | ||
These type metal adapters are also available. ((photos by GA_Ironhead of the XLFORUM http://xlforum.net/forums/showpost.php?p=2163034&postcount=5)) \\ | These type metal adapters are also available. ((photos by GA_Ironhead of the XLFORUM http://xlforum.net/forums/showpost.php?p=2163034&postcount=5)) \\ | ||
+ | (Right) - Carb Adapter, HRS-42 and OEM CV Carb To S-and-S Super E Manifold. ((https://secure.vulcanworks.net/store/Carb-Adapter-HRS-42-and-OEM-CV-Carb-To-S-and-S-Super-E-Manifold.html)) \\ | ||
{{:techtalk:ref:carb:press-on_carb_adapter.jpg?direct&300|}} {{:techtalk:ref:carb:non_press_carb_adapter.jpg?direct&300|}} | {{:techtalk:ref:carb:press-on_carb_adapter.jpg?direct&300|}} {{:techtalk:ref:carb:non_press_carb_adapter.jpg?direct&300|}} | ||
Line 127: | Line 128: | ||
The universal cable made by Barnett for this application is Barnett part number 101-31-30901. \\ | The universal cable made by Barnett for this application is Barnett part number 101-31-30901. \\ | ||
It is described as a 38" cable, and is about 4" too long for this bike setup so a new one was made. \\ | It is described as a 38" cable, and is about 4" too long for this bike setup so a new one was made. \\ | ||
- | <blockquote>I do not understand how they calculate cable length but this must be a 34" cable as it is 4" shorter than the 38". | + | <blockquote>I do not understand how they calculate cable length but this must be a 34" cable as it is 4" shorter than the 38". \\ |
Here is the spec diagram for the 4" shorter throttle cable; if you need to get one special made you can use this as a guide.</blockquote> ((IronMick)) \\ | Here is the spec diagram for the 4" shorter throttle cable; if you need to get one special made you can use this as a guide.</blockquote> ((IronMick)) \\ | ||
Note that the two 90° fittings are not the same. The one to the right is for the carb, the one to the left is for the throttle at the handlebar. \\ | Note that the two 90° fittings are not the same. The one to the right is for the carb, the one to the left is for the throttle at the handlebar. \\ |