Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:carb01v [2019/09/13 21:42] hippysmack [S&S G, GA, GAL] |
techtalk:ref:carb01v [2019/09/13 22:02] hippysmack [S&S GB & GBL] |
||
---|---|---|---|
Line 82: | Line 82: | ||
GBL \\ | GBL \\ | ||
- | {{:techtalk:ref:carb:sands_carbs_10_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1786621)){{:techtalk:ref:carb:sands_carbs_11_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1786621)) \\ | + | This carb will be fine on an 88" motor. Here's the basic stuff you need to deal with. \\ |
+ | Manifold: use the Super B or Super E manifold. \\ | ||
+ | Air Cleaner: the entire Super B setup is a bolt on to L series. \\ | ||
+ | Throttle: this goes to the action cable of the 2 cable system. Forget the idle cable exists for now. \\ | ||
+ | All sportsters 1972> open the throttle plate when the inner cable retreats into the outer coil. \\ | ||
+ | In other words, the braided cable 'pulls' the throttle plate open. The L series (except mgl) is set up for the 1971< throttle plate actuation. \\ | ||
+ | In this setup the inner cable was not braided. It was a solid wire because the inner wire pushed the throttle plate open. \\ | ||
+ | You need to reverse this action at the carb. | ||
+ | For instance: \\ | ||
+ | 1st get a Super B throttle shaft and install it in the GAL. It's longer on the forward end compared to the GAL shaft. \\ | ||
+ | The added length will allow you to install a second throttle lever assembly on the longer shaft. This lever is also Super B. \\ | ||
+ | See the first pic below. The shaft extension will be less (but still enough) on a GAL. \\ | ||
+ | {{:techtalk:ref:carb:sands_gbl_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=2004343&page=2)) {{:techtalk:ref:carb:sands_carbs_10_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1786621)){{:techtalk:ref:carb:sands_carbs_11_by_dr_dick.jpg?direct&300|}} ((photo by Dr Dick of the XLFORUM http://xlforum.net/forums/showthread.php?t=1786621)) \\ | ||
{{:techtalk:ref:carb:sands_gbl_carb_1_by_monte03.jpg?direct&300|}} ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1022912&page=7)) {{:techtalk:ref:carb:sands_gbl_carb_2_by_monte03.jpg?direct&300|}} ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1022912&page=7)) {{:techtalk:ref:carb:sands_gbl_carb_3_by_monte03.jpg?direct&300|}} ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1022912&page=9)) \\ | {{:techtalk:ref:carb:sands_gbl_carb_1_by_monte03.jpg?direct&300|}} ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1022912&page=7)) {{:techtalk:ref:carb:sands_gbl_carb_2_by_monte03.jpg?direct&300|}} ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1022912&page=7)) {{:techtalk:ref:carb:sands_gbl_carb_3_by_monte03.jpg?direct&300|}} ((photo by Monte03 of the XLFORUM http://xlforum.net/forums/showthread.php?t=1022912&page=9)) \\ |