Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
techtalk:ref:carb04 [2019/03/26 01:33]
hippysmack [Patriot Defender] 		techtalk:ref:carb04 [2019/06/14 03:17]
hippysmack [Exhaust Bracket Mods]
Line 312: Line 312:
  
 [[:​techtalk:​menu|{{:​techtalk:​gototechnicalmenu.jpg|}}]] [[:​techtalk:​menu|{{:​techtalk:​gototechnicalmenu.jpg|}}]]
 +
 +====== Exhaust Bracket Mods ======
 +Exhaust brackets can be fabricated to fit just about any configuration needed. \\ 
 +(especially when using aftermarket pipes) \\
 +
 +Mount the pipes to the heads with proper torque. \\ Allow them to **gently** sit on their own. \\ 
 +This allows for vertical and horizontal measurements to be taken from the point where the mount mates to the pipes. \\
 +
 +Below is the bracket that comes with the purchase of a set of Thunderheaders. \\
 +This particular bracket was slightly too low and recessed to fit on a 98 1250. \\
 +(it may have been fine for stock 1200 heads) \\
 +The plate on the bracket was cut into and another plate was welded to it to extend the mounting holes. \\
 +With the extra plate simply welded on top of the original one, the height worked out as well. \\
 +
 +|  Thunderheader bracket mod. ((photos by Hippysmack)) ​ |||
 +|{{:​techtalk:​ref:​carb:​thunderheader_bracket_mod_3_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​thunderheader_bracket_mod_2_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​thunderheader_bracket_mod_1_by_hippysmack.jpg?​direct&​300|}}|
 +|{{:​techtalk:​ref:​carb:​thunderheader_bracket_4_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​thunderheader_bracket_6_by_hippysmack.jpg?​direct&​300|}}|{{:​techtalk:​ref:​carb:​thunderheader_bracket_7_by_hippysmack.jpg?​direct&​300|}}|
 +
 +
 +
 +
 +
 +
  
 \\ \\
  

Trace: