Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
techtalk:ref:carb07 [2019/10/15 00:24] hippysmack [Adjustable Main Jet (L76-87)] |
techtalk:ref:carb07 [2019/10/15 03:24] hippysmack [Velocity Stack] |
||
---|---|---|---|
Line 94: | Line 94: | ||
It requires a total of 2 gaskets (included) to install. ((photos by Hippysmack)) \\ | It requires a total of 2 gaskets (included) to install. ((photos by Hippysmack)) \\ | ||
+ | This is a "V-Ductor" from CV Performance. ((https://cv-performance.com/v-ductor-installation)) \\ | ||
|{{:techtalk:ref:carb:velocity_stack_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:carb:velocity_stack_2_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:carb:velocity_stack_1_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:carb:velocity_stack_2_by_hippysmack.jpg?direct&300|}}| | ||
+ | |||
+ | * Remove the air cleaner backing plate. | ||
+ | * Place a gasket onto the backing plate, then the V-Ductor and another gasket (2 supplied in the kit). | ||
+ | * The smaller end of the cone faces into the carb. | ||
+ | * Install the new assembly onto the carb and torque to factory specs. | ||
+ | * backing plate with as normal against the V-Ductor. Installation of your air box will vary depending upon the | ||
|{{:techtalk:ref:carb:velocity_stack_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:carb:velocity_stack_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:carb:velocity_stack_5_by_hippysmack.jpg?direct&300|}}| | |{{:techtalk:ref:carb:velocity_stack_3_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:carb:velocity_stack_4_by_hippysmack.jpg?direct&300|}}|{{:techtalk:ref:carb:velocity_stack_5_by_hippysmack.jpg?direct&300|}}| |